Skip to content
SkyBit

LiPo battery: care and safety

A LiPo battery gives an FPV drone the current it needs, but handled wrongly it is damaged and can catch fire. These are the basic rules: how to choose, charge and store a pack, and when to stop using it.

Choosing the right pack

Check two things: the cell count and the connector. A 65mm or 75mm whoop runs on 1S; a 5-inch freestyle drone runs on 4S or 6S with an XT60 connector. Putting a pack with more cells into a drone than it was built for destroys the electronics in one flight.

Charging

  • Charge only with a charger made for LiPo, and select the right cell count on it.
  • Balance charge a multi-cell pack, so every cell is charged evenly.
  • Do not leave a battery unattended while it charges, and do not charge it on a flammable surface.
  • Do not charge a swollen or damaged pack, or one that is still hot from a flight.

In flight

Do not run a pack all the way down: deep discharge damages a LiPo. When the voltage drops, land and swap the pack. After a crash, look the pack over — if it has swollen, been punctured or bent, stop using it.

Storage

If you are not flying for a few days, bring the packs to storage voltage — about 3.8 volts per cell. A pack stored fully charged or empty wears out faster. Keep them somewhere dry and cool, away from anything flammable.

For a whoop's 1S packs a storage board does this: it charges several packs at once and brings them to storage as well. Chargers: Prices from 130 ₾ to 685 ₾, 6 models.

When to stop using one

Do not charge or use a pack that is swollen, punctured or deformed. Do not put such a battery in the ordinary rubbish.

LiPo or Li-ion

18650 and 21700 Li-ion cells are a different chemistry from a LiPo: they hold more energy for their weight but give it up far more slowly. That suits long range packs, goggles and controllers, and does not suit a freestyle drone.

Drone batteries: Prices from 25 ₾ to 350 ₾, 11 models.

Guides